Repair of dental micromotor SDE-H37L1 SaeYang Microtech for Marathon milling machines

Repair of dental micromotor SDE-H37L1 SaeYang Microtech for Marathon milling machines

Before starting the repair process, it is necessary to take certain preparatory actions. First, turn off the micromotor and disconnect it from the power source. Remove the nozzle and open the housing of the micromotor using a special key. Check the condition of internal parts, pay special attention to bearings and rings.

If it is necessary to replace the bearings, they should be replaced with similar dimensions and specifications. Install new bearings and lubricate them with grease.

It is also possible that the rings need to be replaced. Check them for damage and wear. If the rings need to be replaced, install new rings using the appropriate tools.

After replacing the bearings and rings, check the operation of the micromotor. Connect it to a power source and turn it on. Check that the micromotor is running at full speed and that there are no unpleasant sounds or vibrations.

If, after replacing the bearings and rings, the micromotor still does not work properly, there may be a problem with the electrical system. In this case, contact a professional service center for further assistance.